what is subsidiary class for mercury

Go to Setup > company > Subsidiaries. Example: ETHANOL SOLUTION with more than 24% ethanol, by volume (UN1170). What types of other dangerous goods safety marks may be required? Regs. For example, UN2744, Cyclobutyl chloroformate, 6.1, (8, 3), PG II. Shipping descriptions for hazardous materials offered or intended for transportation by rail that contain all the information required in this subpart and that are formatted and ordered in accordance with recognized electronic data interchange standards and, to the extent possible, in the order and manner required by this subpart are deemed to comply with this paragraph. Identification number - UN Number either within the center of the placard or on an orange panel safety mark (see the table for other safety marks) when required in Sections 4.15.2 of Part 4 in the TDG Regulation. Wastes: If the product is a waste, then the shipping name is either preceded or followed by the word waste. Which technical names shall be given in parenthesis for generic entries and N.O.S entries? ), code or number for a particular hazard (e.g., 1- Explosive, 2 - Gases, 3 - Flammables), Provide quick identification of the dangerous goods in an emergency (e.g., release of dangerous goods during an incident), Communicate the nature and degree of the danger, Quickly determine if dangerous goods in a mixed load are incompatible, is determined to be a dangerous good under the TDG Regulations, and, displayed against a background of contrasting colour, made of durable, weather-resistant material that will resist coming detached or fade, Select the correct label(s) for each small means of containment (e.g., drum, package, overpack), Make sure that each small means of containment (e.g., package or container) of dangerous goods is properly labelled and marked, Select the correct placards and other safety marks for each large means of containment (e.g., tanker), Display the placards and other safety marks, or provide the appropriate placards to the carrier (when the means of containment or means of transport belongs to the carrier), Confirm that the safety marks are correct, Make sure the safety marks are displayed and remain displayed during transport, Replace safety marks when during transport they are stolen, lost, or defaced, Provide and display appropriate safety marks when the contents of the shipment change (e.g., new consignments are loaded on the means of transport), Remove or cover safety marks when the dangerous good is no longer present. c) The laboratory test results show the product falls into more than one class or packing group. The material's flash point will be displayed with the unit of measure and followed by "c.c." See the example below. Classification is normally done by (or in consultation with): If you are the manufacturer of the product, the product must be tested according to Part 2 of TDG Regulations. It is determined according to the specification in section 2.8 and the Precedence of Classes Table which is provided in Part 2. Wash. Admin. As Marine Pollutants Only: WebMercury (Metallic) Quicksilver; Hydrargyrum; Liquid Silver 1.2. hb```~ !o2)r10Dj`{0j@qz}]1%8Lt29+@b`t/c 9/fiF ~` C# Image from Transport Canada. How does the consignor determine the classification for a dangerous good? Founded in 1961 and headquartered in Los Angeles, Mercury has assets in excess of $4 billion, employs 4,500 people and has more than 8,000 independent agents in 11 states (Arizona, California, They are preferred in the following order: If you cannot find a good match in 1, you move to 2, 3 and 4 by order. Permanganates. The Class 9, lithium battery label, must be displayed on a small means of containment for the following dangerous goods: When a shipment consists of batteries with different UN numbers, all applicable UN numbers must be indicated on one lithium battery or the UN number can be included on separate lithium marks. Column 6 Special Provisions What are the requirements for dangerous goods safety marks when displayed on the means of containment. Mercury. However, the safety mark requirements for large means of containment with a capacity of greater than 450 L but less than or equal to 3000 L (i.e., an intermediate bulk container) are: Placards are not required for overpacks as the definition and description for an overpack does not include large means of containment. Product mixture that consists of multiple dangerous goods: If the shipping name is not a specific name, then the technical name of the most dangerous substance needs to be provided in brackets as required in Special Provision 16 in Schedule 2. WebEach subsidiary must be associated with at least one nexus. Not required to be displayed on road vehicles. They will be used to label dangerous goods. ;imX'1r9-Ttomh1!u~cSyK,v=d+2Cl>AmY\t%v|a&H%dl>; CbtgspL4nj(|c24O?DY_L[;!/aw=yAcC)fMZEnti ]~Mal};jv|y{D}odxh*ap-UDw,EY"h7!G07znrn83Qa=Xre:NWMg]3|u`gho7Ay0Cgh!7tf16+OIXe"m>GNkhhu&.7f{,M` =WaJ`I{W2O_eBX;96$ljWt8 It exists in three forms that have different properties, usage, and toxicity. WebProduct Name Mercury(II) sulfate Cat No. Appendix E: Schedule 2 - List of Dangerous Goods, 6 Registration, Approvals and Certification, 8 Manufacture and Modification of Tank Cars and Ton Containers for Transport of Dangerous Goods, 9 Qualifications and Maintenance of Tank Cars and Ton Containers, 10 Selection and Use of Containers for the Handling, Offering for Transport, or Transporting of Dangerous Goods by Rail, 11 Provisions for the One Time Movement of Non-Conforming Containers Presenting Low Safety Risks, Appendix A: Procedure - Liquefied Petroleum Gas Tank Car Emission Standard, Appendix B: Procedure - Anhydrous Ammonia Tank Car Emission Standard, Appendix C: Procedures for Tank-Head Puncture-Resistance Testing, Appendix D: Procedures for Simulated Pool-Fire and Torch-Fire Testing, Appendix E: Schedule 1 - Special Provisions, transportation-related measures and guidance, Methane, compressed or Natural gas, compressed, with high methane content, Methane, refrigerated liquid or natural gas, refrigerated liquid, with high methane content, Methylacetylene and propadiene mixture, stabilized, Dangerous Goods of Class2.1, not listed above, non-cryogenic, Ammonia solutions, relative density less than 0.880 at 15C (59F) in water, with more than 35% but not more than 50% ammonia, Dangerous Goods of Class2.2, not listed above, non-cryogenic, Ammonia solutions, relative density less than 0.880 at 15C (59F) in water, with more than 50% ammonia, Dangerous goods of Class 2.3, not specifically listed, meeting the definition of dangerous goods toxic by inhalation, Hazard Zone B, Dangerous goods of Class 2.3, not specifically listed, meeting the definition of dangerous goods toxic by inhalation, Hazard Zone C, Dangerous goods of Class 2.3, not specifically listed, meeting the definition of dangerous goods toxic by inhalation, Hazard Zone D, Dinitrogen tetroxide, or Nitrogen dioxide, Ethylene oxide or Ethylene oxide, with nitrogen, Sulphur dioxide, liquefied or Sulphur dioxide, Dangerous Goods of Class2.3, not listed above, Dimethylhydrazine, symmetrical or 1,2-Dimethylhydrazine, Organochlorine pesticide, liquid, flammable, toxic, flash point less than 23C (73F), Petroleum sour crude oil, flammable, toxic, Dangerous Goods of Class 3, Packing Group I, not listed above, Ethanol and gasoline mixture, with more than 10 percent ethanol, Organochlorine pesticide, liquid, flammable, toxic, flashpoint less than 23C (73F), Dangerous Goods of Class 3, Packing Group II, not listed above, Elevated temperature liquid, flammable, n.o.s., with flash point above 60.5C (141F), at or above its flashpoint, Dangerous Goods of Class 3, Packing Group III, not listed above, Dangerous Goods of Class4.1, Packing Group I. ; UN 1224, KETONES, LIQUID, N.O.S, Example: UN 1993 FLAMMABLE LIQUIDS, N.O.S. Have the answers at your fingertips. When test results and the hazard class criteria are compared, there are three possible conclusions: a) The laboratory test results show the product does not meet any of the criteria for the hazard classes. Initial boiling point is greater than 35C at an absolute pressure of 101.3 kPa. When the dangerous goods safety marks are, primary class label and each subsidiary class label for each of the dangerous goods, as well as the shipping name and UN number, must be displayed on the overpack, the word overpack is required on at least one side for overpacks with capacity less than 1.8 m3 (64 cubic feet), the words overpack on at least two opposite, required to display subsidiary hazard class placard. entries are assigned with special provisions 274 or 318 (see column 6 in the example below). Ohio Admin. For goods having multiple risks which are not specifically mentioned by name in Dangerous Goods List, you have to follow the following hazard precedence rules to determine their primary hazard class and subsidiary class. Code R9-7-1508 - R9-7-1508 - Advance Notification of Nuclear Waste Transportation. In addition -. Has a subsidiary classification of Class 1 (1.1,1.2, 1.3 above the exemption limits), Class 4.3, Class 6.1 (Packing Group I), Class 8 (applies only to UN numbers Access to this website For information on COVID-19 updates, please visit Canada.ca/coronavirus. << The subsidiary hazard class or division number is not required to be entered when a corresponding subsidiary hazard label is not required. (7) The number and type of packages must be indicated. Transport Canada is closely monitoring the COVID-19 situation. The packing group may be preceded by the letters PG (for example, PG II); and. Hazard class placards are required when the dangerous goods are: Hazard class placards are not required or are optional when only the following dangerous goods (one or more) are present in the shipment: Examples are available from the TDG Directorates FAQ on Part 4 under the question Can you explain the current placarding requirements?. Make sure the appropriate labels (TDG or Workplace Hazardous Materials Information System (WHMIS) are used in the workplace as required. The solution or mixture is mentioned by name in the Dangerous Goods List; The name mentioned only applies to the pure substance; The hazard class or division, subsidiary risk, packing group or physical state of the mixture or solution is different from that of the substance mentioned; The hazard characteristics and properties of the mixture require different emergency response measures; Is it a pure substance or well-defined mixture (by use) or well-defined article? By using the information provided in the HMT, you can correctly describe the hazardous materials shipment. It exists in several forms: Elemental (metallic) mercury. Other requirements may be listed in other sections, regulations, Codes, or Acts that are not listed in this table. If the dangerous goods are biohazardous substances (Class 6.2), the consignor may use the classification determined by Health Canada or the Canadian Food Inspection Agency. Specific chemical name (e.g., acetone, sulfuric acid, etc. Mixed Loads: dangerous good whose gross mass is 1000 kg or less, and there are at least two different dangerous goods, and the dangerous goods are contained in at least two small means of containment inside a large means of containment. UN Number This column gives the UN number assigned to the dangerous goods under the UN system. Except for combustible liquids, the subsidiary hazard class(es) or subsidiary division number(s) must be entered in parentheses immediately following the primary hazard class or division number. Examples: COTTON WASTE, OILY (UN1364), or REGULATED MEDICAL WASTE, N.O.S. Sodium dithionite or Sodium hydrosulphite, Sodium sulphide, anhydrous or Sodium sulphide, with less than 30% water of crystallization, Dangerous Goods of Class4.2, Packing Group II, not listed above, Fibres or Fabrics, animal or vegetable or synthetic, n.o.s., with oil, Iron oxide, spent or Iron sponge, spent, obtained from hydrocarbon gas purification, Seed cake, with more than 1.5% oil and not more than 11% moisture, Seed cake, with not more than 1.5% oil and not more than 11% moisture. a document that explains how the dangerous goods were classified. /Producer(Sub Systems, Inc.)/CreationDate(D:20211224145622+05'00')/ModDate(D:20211224145622+05'00')/Creator(Sub Systems, Inc.) Regulations) for the transportation of dangerous goods by road. Code 246-231-140 - 246-231-140 - Advance notification of shipment of irradiated reactor fuel and nuclear waste. Dangerous Goods of Class4.1, Packing Group II, not listed above, Magnesium or Magnesium alloys, with more than 50% magnesium, in pellets, turnings or ribbons, Naphthalene, crude or Naphthalene, refined, Titanium sponge granules or Titanium sponge powders, Dangerous Goods of Class4.1, Packing GroupIII, not listed above, Organometallic substance, solid, pyrophoric, water-reactive, Organometallic substance, liquid, pyrophoric, water-reactive, Phosphorus, white or Phosphorus, yellow, dry or Phosphorous, yellow, in solution or Phosphorous, yellow, underwater, Dangerous Goods of Class4.2, Packing Group I, not listed above, Potassium sulphide, anhydrous or Potassium sulphide, with less than 30% water of crystallization. (ii) For hazardous materials in salvage packaging, an estimate of the total quantity is acceptable. Regulatory information United States of America Inventory Component CAS-No TSCA TSCA Inventory notification - Active/Inactive TSCA - EPA Regulatory Flags Mercury The subsidiary class is the other class that further identifies the hazards of the dangerous goods. CHLORINE DIOXIDE is an example of a product that is forbidden by all routes of transportation as indicated in Schedule 3 with an entry of Forbidden in Column 2 - Hazard Class. NOTE: The table below is for guidance purposes only. Consult Schedule 3 for the shipping name that most precisely describes the dangerous goods. Identification number - UN Number must be displayed within a white rectangle located on the primary class label itself or next to the primary class. Relevant identified uses of the substance or mixture and uses advised against Intended use Application Method 1.3. Gross quantity of Class 1.4 (except Class 1.4S) is 1000 kg or less, Class1.1, 1.2, 1.3 or 1.5 explosives that are not subject to Special provision 85 or 86 in Schedule 2 of the TDG Regulations and the quantity is less than or equal to 10 kg, Class1.1, 1.2, 1.3 or 1.5 explosives that are subject to Special provision 85 or 86 in Schedule 2 of the TDG Regulations and the quantity is less than or equal to 1000 articles.

Wake County Courthouse Wedding, Ymca State Swim Meet 2022 Illinois, Machine Embroidery Needle Chart, Articles W